Can you modify exhaust without voiding warranty?

Can you modify exhaust without voiding warranty?

NO. It’s also illegal for a dealer to deny you the OE warranty because you have changed the exhaust system.

What mods will void my warranty?

Altered odometer: If the odometer has been tampered with, the dealer won’t know the exact mileage of the vehicle, which can void your warranty. Aftermarket alterations: Most manufacturers will void the warranty if you modify your vehicle in any way or install aftermarket components. 1 Nov 2022

What is a disadvantage of AFM?

The major disadvantage of the atomic force microscope is that it can only obtain surface information from samples. As a result, AFM cannot replace the valuable functions of optical microscopy, scanning fluorescence microscopy or transmission electron microscopy.

How much fuel does DFM save?

DFM in GM engines can shut down any number of cylinders, following 17 different patterns, depending on driving conditions and throttle input. The system helps GM’s OHV 6.2L V-8 achieve a 2-mpg (0.9 km/L) gain in real-world fuel efficiency without sacrificing any of the engine’s 420 hp and 460 lb. -ft.

Is it bad to turn off AFM?

To prevent spending big money on AFM related repairs, the best option is to simply delete or disable the AFM system. Not only is it a good thing to do for preventative maintenance, it also gives you a better exhaust sound and keeps your car in V8 mode at all times. 28 Sept 2021

Will AFM delete stop oil consumption?

When you eliminate the AFM system, the extra oil is no longer needed. Excess oil will be pushed out of the pressure relief valve into the oil pan. This will spray oil on the bottom of the cylinder walls which can cause oil burning, especially in high-rpm engines. 30 Nov 2017

Does AFM cause vibration?

Some drivers may also notice a very slight vibration in either the accelerator pedal, floor pan and/or the steering wheel. This is a normal condition for AFM equipped vehicles and no repairs should be attempted.

What is the benefit of DOD delete?

DOD Delete or Displacement on Demand, also known as AFM, is a fuel management approach for large displacement gasoline engines. The goal is to decrease the number of cylinders burning fuel during light engine load to improve the fuel economy. 6 Sept 2022

Which is better AFM or DFM?

DFM makes these calculations about 80 times every second. This advanced engineering technology allows V8 engines to operate in 17 various cylinder patterns. This is a dramatic improvement over AFM, which only had two operating modes: four cylinders and eight cylinders. 18 May 2022

How do I know if I have DFM?

You’ll know when you have DFM feedback for a part based on the yellow badge that pops up on your CAD preview, and by the yellow warning above your quote.

What is the fastest GM engine?

¡°The ZZ632 sits at the top of our unparalleled crate engine lineup as the king of performance. It delivers incredible power, and it does it on pump gas.¡± … Chevrolet Performance ZZ632/1000. Chevrolet Performance ZZ632/1000 Power 1,004 hp @ 6600 rpm Torque 876 lb-ft @ 5600 rpm Maximum Recommended Engine Speed 7,000 rpm 9 more rows ? 20 Oct 2021

What year did GM stop using AFM?

General Motors employs a number of different technologies to boost fuel economy, but one of these technologies, namely Active Fuel Management (AFM), has nearly been phased out from the 2022 Silverado engine lineup. 15 Sept 2021

What cylinders shut off with AFM?

AFM (Active Fuel Management) To provide maximum fuel economy under light load driving conditions, the engine control module (ECM) will command the cylinder deactivation system ON to deactivate engine cylinders 1, 7, 6, and 4, switching to a V4 mode. 2 Mar 2020

Why do lifters start tapping?

A blocked oil passage or low oil pressure can cause lifters to produce a tap or tick due to a lack of lubrication.

Does lifter tick increase with RPM?

Tick increases speed with increase of rpm – Motor Vehicle Maintenance & Repair Stack Exchange. Stack Overflow for Teams ¨C Start collaborating and sharing organizational knowledge.

Why is my engine knocking when it runs without oil?

Knocking here is caused by failed crankshaft bearings and is mostly caused from loss of oil pressure or running the engine without enough oil. There are a few knocking noises that may not originate from worn engine internal parts and low oil pressure. 14 Feb 2018

What happens when AFM fails?

Any time an engine has failed AFM lifters the lifter guides must be replaced, the lifter bores must be measured, and the VLOM must also be tested for proper operation, or replaced. In addition the VLOM oil filter must be replaced as well.

Does AFM burn oil?

How The AFM System Can Cause Excessive Oil Consumption. The AFM excessive oil consumption problem usually crops up on vehicles that go on long highway drives. These kinds of trips don’t put much stress on the engine, so the AFM system deactivates pistons.

How do I know if my AFM lifter is bad?

The symptoms of a cam or lifter failure usually involve a chirping, ticking, squealing or squeaking sound accompanied by a Check Engine light and engine misfire codes stored in memory. The misfire condition may not be evident to the vehicle operator.

Does AFM cause lifter tick?

Condition/Concern If an AFM lifter is mechanically collapsed/stuck, low compression will be found on that cylinder during an AFM compression test, along with a consistent valve train tick noise, SES light, DTC P0300 and engine misfires on the related cylinder.